CIGWELD 200i Specifications download pdf (Page 34)

TRANSMIG 200i

INSTALLATION, OPERATION AND SETUP 3-16 Manual 0-5209

4. DO NOT use the regulator as a control valve. When downstream equipment is not in use for extended

periods of time, shut off the gas at the cylinder valve and release the gas from the equipment.

5. OPEN the cylinder valve SLOWLY. Close after use.

User Responsibilities

This equipment will perform safely and reliable only when installed, operated and maintained, and repaired in

accordance with the instructions provided. Equipment must be checked periodically and repaired, replaced,

or reset as necessary for continued safe and reliable performance. Defective equipment should not be used.

Parts that are broken, missing, obviously worn, distorted, or contaminated should be replaced immediately.

The user of this equipment will generally have the sole responsibility for any malfunction, which results from

improper use, faulty maintenance, or by repair by anyone other than an accredited repairer.

CAUTION

Match regulator to cylinder. NEVER CONNECT a regulator designed for a particular gas or gases to

a cylinder containing any other gas.

Art: A-05087

Figure 3-13: Fit Regulator to Cylinder

Installation

1. Remove cylinder valve plastic dust seal. Clean the cylinder valve outlet of impurities that may clog

oriﬁces and damage seats before connecting the regulator.

Crack the valve (open then close) momentarily, pointing the outlet away from people and sources of

ignition. Wipe with a clean lint free cloth.

2. Match regulator to cylinder. Before connecting, check that the regulator label and cylinder marking

agree and that the regulator inlet and cylinder outlet match. NEVER CONNECT a regulator designed

for a particular gas or gases to a cylinder containing any other gas.

3. Connect the regulator inlet connection to cylinder or pipeline and tighten it ﬁrmly but not excessively,

with a suitable spanner.

4. Connect and tighten the outlet hose ﬁrmly and attach down-stream equipment.

5. To protect sensitive down-stream equipment a separate safety device may be necessary if the regulator

is not ﬁtted with a pressure relief device.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

No comments

CIGWELD 200i Specifications Page 34